Bay BayStack 400-ST1 Manual de Instruções descarregar pdf (Página 33)

Adding Units to the Stack

This section describes how to add one or more units to the

middle of a stack or to the end of a stack.

Adding Units to the Middle of a Stack

To add one or more units to the middle of a stack,

complete the following steps:

1. Determine the position of the new units in the

existing stack (Figure 14).

For example, the shaded units (units 5 and 6) in

Figure 14 show two new units to be added to the

stack. The new units are numbered as unit 5 and unit 6

because they are additions to an existing four-unit

stack.

2. Disconnect the cascade cable from the Cascade A

In connector at unit 3.

Leave the other end of the cascade cable connected to

the Cascade A Out connector at unit 2.

3. For 19-inch rack configurations, move the units

two spaces lower in the rack.

Note:

Refer to your switch’s

User Guide

for

information about installing units on a tabletop or in a

standard 19-inch utility rack.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 41 42

Sem comentários

Bay BayStack 400-ST1 Manual de Instruções Página 33